01521 tyre-pressure sensor faults and missing signals

The useful part of a 01521 scan entry comes after the number. “Lower limit exceeded” and “No signal/communication” should not be written down as the same fault.

Start with the tyres

Check pressures and tyre condition using the car’s handbook and pressure label. Do this before deciding that a sensor is reporting incorrectly. A genuine leak and an electronic fault can exist on the same car.

Ross-Tech’s 01521 reference covers low pressure, absent sensors and faulty sensors under the relevant descriptions. It also recommends checking individual sensor information. That does not mean every occurrence needs a new set of sensors.

Has the wheel set changed?

Tell the workshop if the warning began when winter wheels, used wheels or replacement alloys were fitted. Keep any information about the sensors supplied with them. “They came off another Golf” is not enough to confirm that the installed sensors suit your particular vehicle.

When you contact us, say which set was fitted when the system last worked and which set is on the car now. Note whether pressure readings are missing, out of date or apparently wrong. Include the complete scan entry and any sensor-tool report already available.

Keep the wheel identity clear

If the system does not identify wheel positions, avoid guessing that “sensor 1” must be the left-front wheel. Ask the technician how each sensor response was matched to a physical wheel. Clear identification matters when only one unit needs attention.

Send AXION the warning and vehicle details. For a problem following replacement sensors, read programming versus relearning before ordering more parts.

Use the full fault description from your scan and the repair information for your vehicle.

Leave a Comment

Your email address will not be published. Required fields are marked *